SGM Technology for lighting GB
Pilot 3000 Us
er’s Manual 1.00
- 75 -
HILITE USE
HILITE is a key allowing to “open” (Dimmer full) the projectors selected in order to detect them.
The cases when using HILITE are:
Physical detecting of one or more projectors
to detect the physical position of the projectors installed:
- press the HILITE key
- by pressing the fixture and/or groups keys the related projectors will switch on.
For an easy detecting of the physical position on the stage.
Palette modification
Normally the Palettes do not include Dimmer information (which is reserved to the Dimme s Pa ettes).
So it is necessary to see them during the phases of their eventual editing.
- press the HILITE key
- load in the editor the palette to modify (i.e.Red Color)
- modify the palette
- update the palette
Without active HILITE, it wouldn’t have been possible to visualize the palette.
Programming with the Controllers
HILITE owns two statuses. In fact by continuously pressing the HILITE key for more than two seconds,
you will bring the HILITE status in “RECORD” mode.
The mode is recognizable as active when the LED blinks, whilst n the NORMAL mode the key led is on
and fix.
The RECORD mode allows creating new Cues using Manu -Cu s previously stored into the Controllers.
The procedure is the following:
- Keep pressed the HILITE key until activating the RECORD status (blinking led)
- Control the Controllers which will automatically assign their status to the Editor.
- Save the editor status as new Cue
HILITE’s RECORD mode is used to create new immer Cues, when the Controllers already own the
memories for the dimmer control.
This method allows a more rapid and precise programming.
ATTENTION!!
Oppositely to LOCATE, HILI E activation does not effect the Editor except for the RECORD
mode.
To Next Page
Loading...