SGM Technology for lighting GB
Pilot 3000 Us
er’s Manual 1.00
- 43 -
Stand-By Time
This option allows choosing with which time the projectors will be “released”, when they receive the
command “Release” from the Playback or “Clear” from the Editor. These commands normally shut down the
projectors controlled by Cue or Editor. This shut down time can be assigned through “Stand-By Time”
To modify the Stand-by time:
Press the Stand-by Time key
Act on the wheel “Change” until visualizing the time value desired on the field near the key
Press Done! to end and go out from Options
Playback Mode
This option allows to choose the priority behaviour of the Dimmer channels handled by more Playbacks. The
de
fault mode is normally LTP type (Latest Take Precedence). In this mode, the output of same channels
handled by more Cues is always the one related to the last Cue activated. The HTP (Highest Take
Precedence) mode behaves as the LTP mode with an only difference for the Dimmer Attrib tes, for which a
priority is applied where the Output value is always the highest of all the Cues ru ning no matter which
cue has been activated as latest.
To modify the LTP – HTP Priority:
Press the Playback Mode key
Act on the wheel “Change” until visualizing the time value desi d o the field near the key (HTP or
LTP)
Press Done! to end and go out from Options
To Next Page
Loading...