Sharp MX-2314N - Page 171

MX-3114N SIMULATION 6 – 38
27-5
Purpose
Setting
Function (Purpose)
Used to set the machine tag No. (This func-
tion allows the host computer to check the
machine tag No.) (FSS function)
Section
Communication (RIC/MODEM)
Operation/Procedure
1) Enter the password (max. 8 digits) with 10-key.
The entered password is displayed on the column of "NEW”.
In order to correct the entered password, press the [clear] key
to delete the entered value one digit by one digit.
2) Press [SET] key.
27-6
Purpose
Setting
Function (Purpose)
Used to set of the manual service call.
(FSS function)
Section
Operation/Procedure
1) Enter the set value with 10-key.
2) Press [OK] key.
The set value in step 1) is saved.
G TONER ORDER
TIMING(K)
EMPTY Toner order auto send
timing setting (K)
Empty 0 - 11 0 6
NEAR_END Near end 1
0.05 0.05 2
0.1 0.1 3
0.15 0.15 4
0.2 0.2 5
0.25 0.25 6
0.3 0.3 7
0.35 0.35 8
0.4 0.4 9
0.45 0.45 10
0.5 0.5 11
H TONER ORDER
TIMING(C)
EMPTY Toner order auto send
timing setting (C)
Empty 0 - 11 0 6
NEAR_END Near end 1
0.05 0.05 2
0.1 0.1 3
0.15 0.15 4
0.2 0.2 5
0.25 0.25 6
0.3 0.3 7
0.35 0.35 8
0.4 0.4 9
0.45 0.45 10
0.5 0.5 11
I TONER ORDER
TIMING(M)
EMPTY Toner order auto send
timing setting (M)
Empty 0 - 11 0 6
NEAR_END Near end 1
0.05 0.05 2
0.1 0.1 3
0.15 0.15 4
0.2 0.2 5
0.25 0.25 6
0.3 0.3 7
0.35 0.35 8
0.4 0.4 9
0.45 0.45 10
0.5 0.5 11
J TONER ORDER
TIMING(Y)
EMPTY Toner order auto send
timing setting (Y)
Empty 0 - 11 0 6
NEAR_END Near end 1
0.05 0.05 2
0.1 0.1 3
0.15 0.15 4
0.2 0.2 5
0.25 0.25 6
0.3 0.3 7
0.35 0.35 8
0.4 0.4 9
0.45 0.45 10
0.5 0.5 11
K TEMP HISTORY CYCLE Frequency of acquiring the temperature and humidity history 1 - 1440 60 Unit: min.
L LOG OUTPUT CAPACITY(PCU) Log output capacity 0 - 50 30 Unit: [KB]
Item/Display Content
Setting
range
Default
value
Remarks
0 Allow (Default)
1 Inhibit