Sharp MX-2314N - Page 236

MX-3114N SIMULATION 6 – 103
62-6
Purpose
Operation test/check
Function (Purpose)
Used to perform the self diagnostics of the
hard disk.
Section
Operation/Procedure
1) Select the self diag area.
2) Press [EXECUTE] key.
The self diag operation is performed.
E7-03 error occurs. If there may be a trouble in the HDD, use this
simulation to cheek the HDD.
When the operation is completed, [EXECUTE] key returns to the
normal display.
Normal completion  "OK (RESULT:0)" is displayed.
Abnormal end  "NG (RESULT: Other than 0)" is displayed.
* If the simulation cannot be executed or terminated abnormally for
some reason, "ERROR" is displayed on the corresponding sec-
tion.
62-7
Purpose
Operation test/check
Function (Purpose)
Used to print the hard disk self diagnostics
error log.
Section
Operation/Procedure
1) Press [EXECUTE] key.
ERROR LOG SECTOR of the SMART function is executed, and
the result is printed.
When the operation is completed, [EXECUTE] key returns to the
normal display.
62-8
Purpose
Data clear
Function (Purpose)
Used to format the hard disk/SD Card.
(HDD: Excluding the Operation Manual, the
watermark data, and the system area) (SD
Card: User data)
Section
Operation/Procedure
1) Press [EXECUTE] key.
2) Press [YES] key.
Used to execute the hard disk format.
When the operation is completed, [EXECUTE] key returns to the
normal display.
* When the HDD formatting (except for the system area) is not
completed normally, "HDD FORMAT (EXCEPT SYSTEM AREA)
NG" is displayed.
62-10
Purpose
Data clear
Function (Purpose)
Used to clear the job completion list data.
Section
Operation/Procedure
1) Press [EXECUTE] key.
2) Press [YES] key.
Used to delete the job log data.
When the operation is completed, [EXECUTE] key returns to the
normal display.
62-11
Purpose
Data clear
Function (Purpose)
Used to delete the document filing data.
Section
Operation/Procedure
1) Press [EXECUTE] key.
2) Press [YES] key.
Used to delete the document filing data.
When the operation is completed, [EXECUTE] key returns to the
normal display.
62-12
Purpose
Setting
Function (Purpose)
Used to set Enable/Disable of auto format
in a hard disk trouble.
Section
Operation/Procedure
1) Enter the set value with 10-key.
2) Press [OK] key.
The set value is saved.
When it is set to Enable, if a read error of HDD occurs in the system
data storage area (FAX/device cloning data, etc.), only the system
data storage area is cleared.
62-13
Purpose
Data clear
Function (Purpose)
Used to format the hard disk. (Operation
Manual, watermark data only)
Section
Operation/Procedure
1) Press [EXECUTE] key.
2) Press [YES] key.
The operation manual data are deleted.
When the operation is completed, [EXECUTE] key returns to the
normal display.
SHORT S.T Partial area diag
EXTENDED S.T All area diag
A 0 Enable
1 Disable (Default)