Sharp MX-2314N - Page 306

MX-3114N MAINTENANCE 9 – 7
8 Paper
registration
section
(paper
transport
section)/
Paper exit
section/ADU
section
PS unit 1 Registration
roller (idle)
✕      
2 Registration
roller (drive)
✕      
3 Transport
roller 5
✕      
4Sensors ✕✕✕✕✕✕✕✕✕
Right door unit 5 Transport
roller 7
✕      
6 Transport
roller 8
✕      
7 Paper exit
roller 2
✕      
8 Discharge
brush
✕✕✕✕✕✕✕✕✕
9Sensors ✕✕✕✕✕✕✕✕✕
Fusing rear
unit
10 Transport
roller 6
✕      
Paper exit unit 11 Paper exit
roller 1
✕      
12 Discharge
brush
✕✕✕✕✕✕✕✕✕
13 Sensors ✕✕✕✕✕✕✕✕✕
Other 14 Paper dust
removing
unit

– Paper
guides
Clean with alcohol.
9Drive
section
Main drive unit
Belt drive unit
1Gears
(grease)
✕✕✕✕✕✕✕✕✕Apply to the specified
position when checking.
FLOIL G-313S
2 Shafts
(grease)
✕✕✕✕✕✕✕✕✕
3 Shaft earth
sections
(conduction
grease)
✕✕✕✕✕✕✕✕✕Apply to the specified
position when checking.
FLOIL GE-676
4Belts ✕✕✕✕✕✕✕✕✕
5Sensors ✕✕✕✕✕✕✕✕✕
Transport
drive unit
6Belts ✕✕✕✕✕✕✕✕✕
7 Connection
arm
✕✕✕✕✕✕✕✕✕Apply to the specified
position when checking.
HANARL FL-955R
Fusing drive
unit
8 Shafts
(grease)
✕✕✕✕✕✕✕✕✕
Paper exit
drive unit
9 Shafts
(grease)
✕✕✕✕✕✕✕✕✕
10 Belts ✕✕✕✕✕✕✕✕✕
10 Fusing
section
Fusing unit 1 Lower
separation
pawl
✕ – ✕ – ✕ – ✕ – ✕
2 Lower
separationp
awl spring
✕ – ✕ – ✕ – ✕ – ✕
3 Separation
plate
✕ – ✕ – ✕ – ✕ – ✕
4 Oil applying
roller
✕       
5 Backup
roller
✕       
6 CL roller
bearing
✕       
7 Lower
thermistor
✕ – ✕ – ✕ – ✕ – ✕ Replace as needed.
8 Pressure
roller gear
✕ – ✕ – ✕ – ✕ – ✕
9 Pressure
roller
bearing
✕ – ✕ – ✕ – ✕ – ✕
Section/
Unit work
sequence
Section name Unit name
Parts work
sequence
Part name
When
calling
100
K
200
K
300
K
400
K
500
K
600
K
700
K
800
K
Remark