Sharp MX-2314N - Page 309

MX-3114N MAINTENANCE 9 – 10
3Transfer
section
Primary
transfer unit
5 Primary
transfer belt
follower
roller
–  – – 
6 Primary
transfer belt
tension
roller
✕  – – 
7 Registration
backup
roller
✕  – – 
8 Y auxiliary
roller
✕  – – 
9 PTC backup
roller
✕  – – 
10 Primary
transfer
roller
✕✕– ✕✕✕– ✕✕Replace as needed.
11 Transfer
cleaner
seals F/R
✕✕– ✕✕✕– ✕✕
12 Primary
transfer belt
cleaner
blade
✕  – – 
13 Primary
transfer
toner
reception
blade
✕✕– ✕✕✕– ✕✕Replace as needed.
14 Primary
transfer
operation
mode
detector
✕  – – 
Secondary
transfer unit
1 Secondary
transfer belt
follower
roller
✕ –  –  –  – 
2 Secondary
transfer belt
✕
–  –

–  –

Never use alcohol or
solvents for cleaning.
Replace at every 300K.
3 Secondary
transfer belt
drive roller
✕ –  –  –  – 
4 Secondary
transfer
backup
roller
✕ –  –  –  – 
5 Secondary
transfer belt
tension
roller
✕ –  –  –  – 
6 Secondary
transfer
roller
✕ – ✕ – ✕ – ✕ – ✕ Replace as needed.
7 Secondary
transfer
drive gear
✕ – ✕ – ✕ – ✕ – ✕
8 Separation
cam
✕ – ✩ – ✩ – ✩ – ✩ When replacing, apply
HANARL FL-955R to
the shaft section.
9 Secondary
transfer
frame
✕ – ✩ – ✩ – ✩ – ✩
4 Other Other 1 PTC unit ✕ 
–



–


Replace. Reciprocate
the PTC cleaning rod
back and forth 3 times.
2 Image
density
sensor
✕  – 

 – 

Remove dirt from the
light emitting/receiving
sections (transparent
plastic sections) of the
sensor with dry waste
cloth. *
1
Section/
Unit work
sequence
Section name Unit name
Parts work
sequence
Part name
When
calling
200
K
300
K
400
K
600
K
800
K
900
K
1000
K
1200
K
Remark