Sharp MX-2314N - Page 403

MX-3114N DISASSEMBLY AND ASSEMBLY 10 – 57
7) Remove the web roller (on the feeding side).
After assembling the web unit, rotate the drive gear until the
end position of the start mark on the web sheet comes to the
pressure roller.
d. Lower thermistor
1) Remove the paper guide.
2) Disconnect the connector, and remove the mounting plate.
Remove the lower thermistor from the mounting plate.
e. Pressure roller gear, Pressure roller gear bearing, Pressure
roller
1) Remove the drive plate, and remove the gear.
Pressure roller
End position of the start mark
1
1
2
4
3
1
2
3
3
1
2
1