Sharp MX-2314N - Page 402

MX-3114N DISASSEMBLY AND ASSEMBLY 10 – 56
c. Web guide shaft, Web pressure roller bearing, Web
pressure roller, Web roller
1) Disconnect the connector and remove the harness. Remove
the web unit.
2) Remove the holder.
When assembling, place the actuator tip on the outside of the
web sheet.
3) Remove the web guide shaft.
4) Remove the web roller (on the winding side).
5) Remove the spring and the web pressure roller bearing, and
remove the web pressure roller.
6) Remove the web guide shaft.
2
1
1
1
1
2
1
1
2
2
3