2-19
COPIER►BASIC PROCEDURE FOR MAKING COPIES
3
Select the 2-sided copy mode.
(1) Tap the [1→2] key.
(2) When the output is set to "2-sided", select "Tablet" or
"Book" in "Output Binding".
(3) After the settings are completed, tap .
The [2→2] key and [1→2] key cannot be used when copying from the document glass.
4
Check the paper (tray) and color mode
you want to use for copying, and tap
the keys for any other settings you
want to select.
• Paper Select►page 2-13
• Copy Ratio►page 2-26
• Staple/ Punch ►page 2-42, ►page 2-45
• Color Mode►page 2-20
• Orientation►page 2-33
• Exposure►page 2-23
•N-Up►page 2-49
• Card Shot►page 2-52
Depending on the size of the placed original, there may be cases where the same size of paper as the original is not
selected automatically. In this event, change the paper tray manually.
5
Tap the [Color Start] or [B/W Start] key.
6
Set the next original, and tap the
[Color Start] or [B/W Start] key to scan
the original.
Tap the same key you tapped in step 5.
Repeat this step until all originals have been scanned.
7
Tap the [Read-End] key to start copying.
CA
Preview
B/W
Start
Color
Start
Copies
2-Sided Copy
Output Binding
1 → 2
TabletBook
2 → 12 → 21 → 1
(3)
(1)
(2)
Original
Detail
Staple / PunchCopy Ratio2-Sided Copy
Paper
Select
Tray 1 1 → 1
100% Off
Preview
B/W
Start
Color
Start
Copies
CA
8½x11
8½x11
Preview
B/W
Start
Color
Start
Scan
Again
CA
To Next Page
Loading...
