1-31
BEFORE USING THE MACHINE►BEFORE USING THE MACHINE
PERSON SENSOR
This sensor detects the presence of a person that approaches the machine, and automatically wakes the machine from
sleep mode.
Three settings are available for the detection range ( / / ).
The motion sensor detects the movement of sources of heat.
The detection range may vary depending on the installation site and environment (ambient temperature, etc.).
The motion sensor may not operate correctly in the conditions below.
• An object is in front of the motion sensor
• There are scratches or dirt on the motion sensor cover
• The motion sensor is directly exposed to sunlight or air flow
• The motion sensor is damaged
• There is a source of heat such as a heater nearby
• An object is moving in the detection range
To enable the motion sensor
"Setting mode (administrator)" select [System Settings] → [Energy Save] → [Eco Setting] → [Sleep Mode Power Level].
Person sensor
Near Far
Detection range
Approx.
maximum
1.5 m
60 degrees
To Next Page
Loading...
