7-88
SYSTEM SETTINGS►SYSTEM SETTINGS
Image Send Settings
Common Settings
Settings related to the image send function (E-mail, Internet fax, etc.) can be configured.
The operation settings below apply to all image send functions.
Default Settings
Hold settings for a while after scanning has been completed
Use this setting to hold the settings after scanning is completed (until Auto Clear Mode activates).
Job Auto Start Time During Scanning
Set the time at which transmission is automatically started even if the original is still being scanned.
Default Display Settings
Select any of the following 5 base screens that appear when you tap the [Image Send] key or when you tap the ([CA]
key) on the Image Send Mode screen.
•E-mail
• Network Folder
• FTP/Desktop
• Internet Fax
•Fax
• Data Entry
Higher priority is given to the display of address book.
If image send mode is enabled, the Address Book is displayed in place of the initial screen of this mode.
Apply Addresses of Sending Modes Only
When an address is selected from the address book, only the addresses displayed in narrowing mode are applied.
Category Displayed as Default
Select a category to be displayed with the default.
• No Check
• Freq.
• Categories 1 to 32
Display all address type regardless of the mode being displayed currently.
Displays all destinations regardless of the displayed mode when this setting is enabled.
Enlarge Address Book
An enlarged address book list appears.
Image Orientation
Sets the default image orientation.
Initial Exposure Settings
This is used to set the default exposure settings for scanning a document in image send mode. Select [Auto] or
[Manual]. If you select [Manual], set the exposure to one of 5 levels.
For an explanation of settings related to the fax function, see "IImage Send Settings (page 7-165)"
In "Setting mode", if a default address has been configured by selecting [System Settings] → [Image Send Settings] → [Scan
Settings] → [Default Address] → [Default Address Setting], the [Higher priority is given to the display of address book.]
function cannot be used.
When the exposure is set to [Auto], a default original type cannot be selected.
To Next Page
Loading...
