4-88
FACSIMILE►OTHERS FUNCTION
STAMPING SCANNED ORIGINALS(VERIFICATION
STAMP)
This function stamps each original that is scanned using the automatic document feeder, allowing you to verify that all
originals were correctly scanned.
• To use the verification stamp function, the optional stamp unit must be installed.
• When 2-sided originals are used, the front of each original is stamped twice.
• If an error occurs during scanning, an original that was not scanned may be stamped.
• When the "O" mark that is stamped on originals starts to become faint, replace the stamp cartridge.
For the procedure for replacing the stamp cartridge, see "REPLACING THE STAMP CARTRIDGE (page 1-130)
".
1
Place originals in the automatic document feeder.
► AUTOMATIC DOCUMENT FEEDER (page 1-67)
2
Enter the destination fax number.
• Entering a destination number using the numeric keys►page 4-11
• Retrieving a destination from an address book►page 4-12
• Using a search number to retrieve a destination►page 4-15
• Retrieving a destination from a global address book►page 4-16
• Using a transmission log to resend►page 4-18
3
Tap the [Detail] key to change to normal mode.
► Changing mode from each mode (page 4-8)
Originals
Position of verification stamp
Original are
scanned
An "O" mark is
stamped in
fluorescent
pink.
To Next Page
Loading...
