1-64
BEFORE USING THE MACHINE►LOADING PAPER
1
Open the bypass tray.
When loading paper larger than 8-1/2" x 11"R or A4R, pull
out the extension guide.
Pull the extension guide all the way out.
Do not place heavy objects on the bypass tray or press down on the tray.
2
Set the bypass tray guides to the width
of the paper.
3
Load the paper with the print side
facing down.
Insert the paper along the bypass tray guides all the way into
the bypass tray until it stops.
For "Letter Head" and "Pre-Printed", set the paper with the print side up. However, when [Disabling of Duplex] is
enabled, set the print side in the same orientation as in the regular mode (facing down).
• Do not force the paper in.
• If the bypass tray guides are set wider than the paper, move the bypass tray guides in until they correctly fit the width
of the paper. If the bypass guides are set too wide, the paper may skew or be creased.
To display the paper tray settings when paper is detected in the bypass tray
In "Setting mode", select [System Settings] → [Common Settings] → [Paper Settings] → [Tray Settings] → [Display
Paper Tray Settings when bypass tray detects paper.].
To Next Page
Loading...
