7-84
SYSTEM SETTINGS►SYSTEM SETTINGS
*1 When the finisher is installed
*2 When the saddle finisher (large stacker) or finisher (large stacker) is installed
*3 This setting is used to adjust the line width of vector graphics. Except for CAD and other specialized uses, there is
normally no need to change this setting. When "0" is selected, all lines are printed at a width of 1 dot.
*4 Paper sizes that can be used with this function are 11" x 17", 8-1/2" x 14", 8-1/2" x 11", A3, B4, and A4. (This function
may not take effect with some print methods.)
*5 Can be selected when 2-Up is selected.
*6 Can be selected when 4-Up/8-Up is selected.
*7 Only effective when printing PDF, JPEG, and TIFF files.
*8 When a punch module is installed.
Fit To Page
*7
• (Use Fit to Page)
• (Do not use Fit to Page)
Finishing
• (Use Print per Unit)
• (Do not use Print per Unit)
• Staple Position
*1
: None, 1 Staple at Back, 2 Staples, 2 Staples (Top)
• (Use Punch)
*8
• (Do not use Punch)
*8
Separator Page
• Insert Before Job Paper Tray
• Insert After Job Paper Tray
Quick File
• (Disabled)
• (Enabled)
Setup Items Description
To Next Page
Loading...
