7-155
SYSTEM SETTINGS►SYSTEM SETTINGS
• The scheduling function does not support the power management settings in the Preheat Mode and Auto Power Shut-Off
Mode.
• The preset power-off time is subject to the following restrictions:
• If the machine is running due to the current job execution or other reasons, the machine is turned off only after the job has
finished.
• The machine cannot receive printer jobs.
• The machine can receive output jobs, such as received fax data outputs.
• If the Time Specified Output of Received Data setting is enabled, they are output next time the machine is turned on.
• If the power management setting is also enabled, the Power On/Off Scheduling settings precede.
• If the same time is specified, settings are applied in the order of "Setting 1", "Setting 2", and "Setting 3".
• The power is not turned off in the following cases:
• "Automatic deletion when power is turned on" is in progress.
• While the optimization of the hard disk is in progress or while a restart is in progress after the setting mode has been
changed.
• The preset power on/off time is within one minute from when the setting is accepted.
To Next Page
Loading...
