Sharp MX-M264N Service Manual

MX-M264U SIMULATION 6 – 10
5
5-1
Purpose
Operation test/check
Function (Purpose)
Used to check the operation of the display,
LCD in the operation panel, and control cir-
cuit.
Section
Operation panel
Operation/Procedure
The LCD is changed as shown below.
The contrast changes every 2sec from the current level to MAX 
MIN  the current level. During this period, each LED is lighted.
The LCD display contrast change and the LED lighting status are
checked.
5-2
Purpose
Operation test/check
Function (Purpose)
Used to check the operation of the heater
lamp and the control circuit.
Section
Fusing
Operation/Procedure
1) Select the item to be operation checked with the touch panel
key.
2) Press [EXECUTE] key.
The selected heater lamp operates ON/OFF.
When [EXECUTE] key is pressed, the operation is terminated.
5-3
Purpose
Operation test/check
Function (Purpose)
Used to check the operation of the scanner
lamp and the control circuit.
Section
Scanner (reading)
Operation/Procedure
1) Select the item to be operation checked with the touch panel
key.
2) Press [EXECUTE] key.
The scanner lamp lights up for 10 sec.
When [EXECUTE] key is pressed, the operation is terminated.
6
6-1
Purpose
Operation test/check
Function (Purpose)
Used to check the operations of the load in
the paper transport system (clutches and
solenoids) and the control circuits.
Section
Paper transport/Paper exit section
Operation/Procedure
1) Select the item to be operation checked with the touch panel
key.
2) Press [EXECUTE] key.
The selected load performs the operation.
When [EXECUTE] key is pressed, the operation is terminated.
Load operation check method
The load operation is checked by the operation sound. However,
there are some loads which cannot be checked with the operation
sound.
*1: If "Normal rotation" and "Reverse rotation" of a same load are
displayed as different items, when the both are selected at the
same time, "Normal rotation" is performed. In addition, a
change in the rotating direction is accepted only when the
operation is stopped.
HL_UM Main heater lamp (F) (Paper surface heat roller)
HL_US Sub heater lamp (F) (Paper surface heat roller)
SIMULATION
NO.05-01
TEST
SIMULATION NO.05-01
TEST
Section Item/Display Content
Transport/
process
MM Main motor
POM_F*
1
Paper exit reverse motor (normal rotation)
POM_R*
1
Paper exit reverse motor (reverse
rotation)
OSM Shifter motor
PTRC2 Vertical transport clutch 2CS
RRC PS clutch
PSPS Process separation pawl solenoid
POGS1 Paper exit gate solenoid
POGS2 Right paper exit keep solenoid
Paper feed C1LUM Cassette 1 lift-up motor
C1PUC Cassette 1 paper feed clutch
C1PUS Cassette 1 paper feed solenoid
C2LUM Cassette 2 lift-up motor
C2PUC Cassette 2 paper feed clutch
C2PUS Cassette 2 paper feed solenoid
MPFS Manual feed take-up solenoid

Sharp MX-M264N Specifications

General

Print Technology	Laser
Functions	Print, Copy, Scan, Fax
Print Speed	26 ppm
Max Print Resolution	600 x 600 dpi
Standard Paper Capacity	1100 sheets
Max Paper Capacity	2100 sheets
Automatic Duplexing	Yes
ADF Capacity	100 sheets
Scan Resolution	600 x 600 dpi
Copy Speed	26 cpm
Copy Resolution	600 x 600 dpi
Connectivity	Ethernet, USB