Chapter 5: Assembly and Disassembly of Parts
SPD-M20A Service Manual
20
NOTE
When 6 in the diagram below (opening between the right panel bearing and
lower right hinge) is 0.6 mm or greater, insert a 0.5 mm right hinge shim (P/N 228-
43224) between the chassis and the lower right hinge.
8) While pressing the right panel against the jig, push the lower right hinge in the
direction of the screws [C] [E], and tighten the screws.
NOTE
When tightening the screws, make sure that the right panel does not lift up at
3 and 8
due to rotation of the lower right hinge.
Due to the gutter between the hinge and right panel, the right panel will lean
under its own weight and will contact 3 to align the top surface ( about 0.1 mm
depending on the intersection).
To Next Page
Loading...