SICK deTec4

b
T
ightening torque for the screws used to mount the bracket: 5 Nm to 6 Nm.
Tightening torque for the screws used to secure the safety light curtain in the
bracket: 2.5 Nm to 3 Nm ($). Higher torques can damage the bracket, while lower
torques are not secure enough to prevent the safety light curtain from moving.
$
2,5 Nm -
3 Nm
5 Nm -
6 Nm
b
Mak
e sure that the sender and receiver are aligned correctly. The optical lens
systems of the sender and the receiver must be located opposite one another (%).
%
b If necessary, use a spirit level to check that the components are parallel (&).
&
NOTE
W
hen mounting the brackets, take into account that the brackets cannot be mounted
at the same height if different system plugs are used on the sender and receiver.
5 MOUNTING
80
O P E R A T I N G I N S T R U C T I O N S | deTec4 8021645/1EB0/2022-04-28 | SICK
Subject to change without notice