The device also provides user alerts to provide indication of the devices configuration:
•
The Device Not Configured message shall flash up on the LCD after a short duration if the user has
not changed any parameter in the device. The display of the message cannot be disabled as the act of
changing any parameter or loading a user configuration will automatically turn it off.
[sc_7SR5_DeviceNotConfigured, 1, --_--]
•
The device provides indication that the IEC 61850 has been configured. The IEC 61850 Configured
Alert parameter located in the Configuration Device menu can be Enabled to provide a screen
alert message. The message should be Disabled for non IEC 61850 applications. The IEC 61850 Not
Configured parameter is in the Binary Output matrix for mapping to a binary output, LED, and/or
virtual signal.
NOTE
The IEC 61850 Not Configured alert will be displayed sequentially with any other configured alerts.
Basic Structure of the Device Functionality
2.4 Device Startup
Reyrolle 7SR5, Overcurrent Protection Device, Device Manual 35
C53000-G7040-C014-1, Edition 11.2019
To Next Page
Loading...
