CLINITEK Status+ Analyzer Operator’s Guide 17
Introduction
2. Press the on/off button for at least 2 seconds.
The analyzer pulls in the test table. If no strip or cassette is on the
test table, the test table door closes and the analyzer powers off.
If a strip or cassette is still on the test table, the analyzer pushes
out the test table and powers off. The test table remains out.
To pull the test table into the analyzer, power on the analyzer,
remove the strip or cassette on the test table, and then power off
the analyzer.
CAUTION
Do not push the test table fully into the analyzer. The test
table might become jammed and prevent the use of the
analyzer.
To Next Page
Loading...
