Siemens CLINITEK Status+ User Manual

16 CLINITEK Status+ Analyzer Operator’s Guide
Introduction
Powering On/Off
If you power on the analyzer for the first time, the Start Up Wizard
prompts you through a set-up procedure. Also, you must enter a
startup code when you use the analyzer for the first time.
To power on the analyzer, perform the following steps:
1. Press the on/off button on the front of the analyzer.
The analyzer runs a diagnostic test each time you power on the
analyzer.
If this is the first time you powered on the analyzer, the Start Up
Wizard displays and prompts you to select a region.
2. Select a region.
Note If your region does not display in the list, select Other.
The Authorization Code screen displays.
3. For the start up code, enter 2664.
Note If you enter an incorrect start-up code, the Incorrect
Authorization Code error message displays. Select No to
return to the Authorization Code screen and enter 2664.
To power off the analyzer, perform the following steps:
1. Before you power off the analyzer, always ensure that no strip or
cassette is on the test table and that the table and insert are clean.

Siemens CLINITEK Status+ Specifications

General

Display	LCD
Sample Type	Urine
Measurement Method	Reflectance photometry
Type	Urinalysis Analyzer
Test Types	Urine Chemistry
Connectivity	RS232 port
Weight	5.0 kg
Power Supply	100-240 V AC, 50-60 Hz
Data Storage	Up to 200 patient results
Test Parameters	Leukocytes, Nitrite, Urobilinogen, Protein, pH, Blood, Specific Gravity, Ketone, Bilirubin, Glucose
Test Strips	Multistix and other compatible strips