CLINITEK Status+ Analyzer Operator’s Guide 95
System Configuration
2. Enter the password.
3. On the Choose Settings screen, select Remove Password.
The Set Password option displays in the Choose Settings menu.
You no longer need a password to gain access to Instrument Set
Up.
4. Select Done.
Setting up Operator and Patient Information
The operator and patient information settings provide the following
options:
•Quick Test
• Full Test
•Custom Set Up
Quick Test
When you run a Quick Test, the system runs the test and assigns a
sequential test number that displays when the results display or print.
Note You cannot enter patient and operator information with a Quick
Test.
To select a Quick Test, perform the following steps:
1. On the Select Ready screen, select Instrument Set Up.
2. On the Choose Settings screen, select Operator and Patient
Information.
3. Select Quick Test.
The system assigns a sequence number to the test but does not let
you enter patient and operator information. To enter patient and
operator information, see Full Test‚ page 96 and Custom Set Up‚
page 96.
4. Select Next.
5. Select Done.