32 CLINITEK Status+ Analyzer Operator’s Guide
Operations
• A timer counts down the time remaining in the strip analysis
process. After the countdown ends, the analyzer displays the
first page of the test results on the Results screen.
• The results display on the screen for 2 minutes. Then, the
display returns to the Select Ready screen.
• The test table and strip move out of the analyzer.
Note If you set up the analyzer to print the test results
automatically, the Printing screen displays until the printout
finishes. If you set up the analyzer with a connection to a PC, the
analyzer sends the test results to the PC.
Viewing the Urinalysis Strip Quick Test Results
The first page of test results display on the Results screen. You can
view additional pages of the test results and sample interference
noteson the Results screen.
To view additional pages of the urinalysis strip Quick Test results and
the sample interference notes, perform the following steps:
1. Select More to view the remaining test results.
If you use reagent strips with an ID band, you can view sample
interference notes for this test.
2. Select Notes to view the sample interference notes, if the analyzer
generated them for the test.
The Interference notes screen displays up to 5 sample
interference notes.
Note If you disable the Sample Interference Notes setting in
Instrument Set Up, or the analyzer does not generate sample
interference notes, the Notes button does not display. If you run a
test with this feature disabled, the analyzer does not generate
notes at the time of the actual test. If you enable the Sample
Interference Notes setting, and then recall the test results, the
analyzer generates notes for this patient test.
3. Select the up and down arrows to scroll through the notes.
4. Select Done to return to the main Results screen.
To Next Page
Loading...
Need help?
General
