CLINITEK Status+ Analyzer Operator’s Guide 103
System Configuration
6. Select Next 3 times to display the Input Settings-Confirmation
screen.
7. Select Done twice to return to the Select Ready screen.
Changing the Date and Time
The date and time display on the Select Ready screen in the title bar.
The system includes the date and time with the test results in the
format you specify, on the display and the printout.
To change the date and time, perform the following steps:
1. On the Select Ready screen, select Instrument Set Up.
2. On the Choose Settings screen, select Date and Time Settings.
3. On the Set Date & Time screen, use the up and down arrows to
adjust the date and time.
4. Select AM or PM if you want the 12-hour time format.
5. Select Set.
6. Select Done.
To change the date and time format, perform the following steps:
1. On the Select Ready screen, select Instrument Set Up.
2. On the Choose Settings screen, select Date and Time Settings.
3. On the Set Date & Time screen, select Choose Format.
4. On the Choose Format screen, select a date format.
5. Select a time format.
Note If you select the 24-hour format, the AM and PM selections
are not available.
6. Select Done to return to the Set Date & Time screen.
The date and time display in the format you selected.
7. Select Set to confirm your choices and return to the Choose
Settings screen.
8. Select Done to return to the Select Ready screen.
To Next Page
Loading...
Need help?
General
