CLINITEK Status+ Analyzer Operator’s Guide 79
File Management
6 File Management
The system stores the following information:
• System configuration settings
• Up to 950 patient test results
Note When the results list reaches 950 patient tests, the analyzer
deletes the oldest test from the list. You cannot recall the deleted test.
You can perform the following tasks with the results:
• Recall, search, and view the patient test results
• Automatically send all the test results or individual test results to a
computer (if connected)
• Automatically sends the test results to a computer while you test
the sample and when you recall results (if configured, and if
connected)
• Print all the test results or individual test results
• Delete the test results
If you connect the analyzer to a computer through a serial port, you
can send the test results to the host computer. You also can set up the
analyzer to automatically transfer the test results to the computer each
time the analyzer completes a test. For information about connecting
your analyzer to a computer, see Section 1, Introduction, Connecting
the Analyzer to a Computer‚ page 13.
If you run a CLINITEK Status+ analyzer with a CLINITEK Status
connector, see the CLINITEK Status Connect System Operator’s Guide.
To Next Page
Loading...
