CLINITEK Status+ Analyzer Operator’s Guide 13
Introduction
Note The test table insert adapts for use with a Siemens urinalysis
strip or an hCG cassette. Use one side for a strip test and the other
side for a cassette test.
Figure 1-3: The Test Table and Test Table Insert
Connecting the Analyzer to a Computer
To connect the analyzer to a computer, perform the following steps:
1. Purchase a 9-pin null modem serial cable from your local technical
support provider or distributor. See Appendix B, Support
Information.
2. Connect the serial cable to the serial port located on the back of
the analyzer.
3. Connect the other end of the serial cable to the back of the
computer.
To Next Page
Loading...
