34 CLINITEK Status+ Analyzer Operator’s Guide
Operations
Depending on the configuration settings, the test results printout
could include any of the following information:
•Date
•Time
•Test number
•Results
• Sample interference notes (if enabled in Instrument Set Up)
For instructions on how to set up the analyzer so that you can print
the results automatically or send the results to a computer, see
Section 7, System Configuration, Changing the Connectivity
Settings‚ page 110.
Completing the Urinalysis Strip Quick Test
Complete the Quick Test for one strip or continue testing one strip at a
time, until you finish testing all the strips you want to analyze.
To complete the urinalysis strip Quick Test, perform the following
steps:
1. Remove the used urinalysis strip from the test table, and dispose of
it according to your standard laboratory procedures.
2. Wipe the table insert, if necessary (see Section 4, Maintenance,
Weekly Cleaning of the Test Table and Test Table Insert‚ page 57).
3. Report the results to a laboratory supervisor or physician.
4. Select Done to complete the test.
The results display on the screen for 2 minutes. Then, the Prepare
Test screen displays, ready for you to prepare the next strip Quick
Test.
To Next Page
Loading...
Need help?
General
