Siemens LME7 Series Basic Documentation

186/245
Building Technologies Division Basic Documentation LME7... CC1P7105en
Infrastructure & Cities Sector 23 Operation via AZL2… 29.11.2011
23.8.2 Changing the heating engineer's password

Note:
For the OEM to change the heating engineer’s password, c: demands entry of the OEM
password!
P
Vh
min
s%
Bild 56/0707
Parameter 041: blinks.
Press
/
reset
to go to level c: for password changes.
/
reset
P
Vh
min
s%
Bild 164/1107
Letter c: for confirmation appears blinking.
Proceed as described in section Entering the password
and enter the former password.
After entry of the last character, the password must be
confirmed by pressing
/
reset
.
/
reset
P
Vh
min
s%
Bild 57/070 7
Letter n: for new appears blinking.
Proceed as described in section Entering the password
and enter the new password (4 characters).
After entry of the last character, the password must be
confirmed by pressing
/
reset
.
/
reset
P
Vh
min
s%
Bild 58/0707
Letter r: for repeat appears blinking.
Proceed as described in section Entering the password
and repeat entry of the new password.
After entry of the last character, the password must be
confirmed by pressing
/
reset
.
P
Vh
mi n
s%
Bild 59/0707
SEt confirms that the new password has been saved.
P
Vh
min
s%
Bild 56/0707
Parameter 041: blinks again.

Siemens LME7 Series Specifications

General

Brand	Siemens
Model	LME7 Series
Category	Controller
Language	English