Siemens PROFINET SIRIUS 3RW5 - Performing firmware update with micro SD card (3 RW5 HMI High Feature); Replacing the 3 RW5 communication module

9.1.1 Performing 󹪝rmware update with micro SD card (3RW5 HMI High Feature)
Requirements
• Micro SD card with valid 󹪝rmware 󹪝le (*.upd)
You will 󹪝nd more information and requirements for supporting the micro SD card in the
Equipment Manual of the 3RW5 soft starter.
• The valid 󹪝rmware 󹪝le is located in the root directory (topmost level).
• 3RW5 HMI High Feature
Menu "Micro SD card > FW update".
Procedure
Note
Access to micro SD card.
Please note that the micro SD card is inserted in the 3RW5 HMI High Feature during updating of
the 󹪝rmware.
Premature removal of the micro SD card from the 3RW5 HMI High Feature is not permissible and
will terminate updating of the 󹪝rmware. Data could also be lost.
1. Select the folder of the 3RW5 communication module.
2. Select the 󹪝rmware 󹪝le of the 3RW5 communication module and con󹪝rm with the OK button.
You can see the 󹪝rmware update is being performed from the progress bar on the display.
Following successful updating of the 󹪝rmware, the 3RW5 communication module restarts
automatically.
3. Check the new 󹪝rmware version in the "Overview" menu.
Result
You have performed a 󹪝rmware update for the 3RW5 communication module using the Micro SD
card.
More information
You will 󹪝nd more information on operating the 3RW5 HMI High Feature in the Equipment
Manual of the 3RW5 soft starter.
9.2 Replacing the 3RW5 communication module
Communication parameters are stored in the 3RW5 communication module and not
automatically transferred into the replacement device.
Maintenance and service
9.2 Replacing the 3RW5 communication module
SIRIUS 3RW5 PROFINET communication modules
Equipment Manual, 05/2021, A5E35631297002A/RS-AD/004 141