Siemens PROFINET SIRIUS 3RW5 - Remove the COM connecting cable on the 3 RW50 soft starter

5.1.4 Remove the COM connecting cable on the 3RW50 soft starter
Requirements
• 3RW50 soft starter
• Removed hinged cover
Further information on removing the hinged cover can be found in the Equipment Manual
of the 3RW50 soft starter.
• COM connecting cable removed from the 3RW5 communication module (Page 48)
Procedure



Illustration similar
1. Loosen die securing mechanism on the bus connector of the COM connecting cable.
2. Pull the bus connector of the COM connecting cable out of the socket on the 3RW50 soft
starter.
3. Install the hinged cover.
Further information on installing the hinged cover can be found in the Equipment Manual of
the 3RW50 soft starter.
Result
You have disconnected the COM connecting cable from the 3RW50 soft starter.
Connection
5.1 COM connecting cable
SIRIUS 3RW5 PROFINET communication modules
Equipment Manual, 05/2021, A5E35631297002A/RS-AD/004 49