Siemens PROFINET SIRIUS 3RW5 - Removing the Bus Connector

Procedure - 3RW5 PROFINET High Feature communication module



Illustration similar
1. Plug the bus connector of the 󹪝rst cable into the lower socket (Port 2) of the 3RW5 PROFINET
High Feature communication module.
Note
3RW5 PROFINET High Feature communication module with 1 bus connector
If you only connect 1 bus connector you can choose a socket (Port 1 or 2).
2. Plug the bus connector of the second cable into the upper socket (Port 1) of the
3RW5 PROFINET High Feature communication module.
3. Secure the two cables together with a cable tie.
Result
The 3RW5 PROFINET communication module is now properly mounted and connected. You can
integrate the 3RW5 soft starter into the associated network environment.
5.2.2 Removing the bus connector
Requirements
• Diagonal cutter
• Slotted screwdriver with blade width < 2.5 mm
Connection
5.2 Fieldbus
SIRIUS 3RW5 PROFINET communication modules
Equipment Manual, 05/2021, A5E35631297002A/RS-AD/004 51