Siemens PROFINET SIRIUS 3RW5 - Installing the 3 RW5 communication module on a level surface







r
Illustration similar
1. Remove the fastening screws from 3RW5 communication module.
2. There is a small gap above the upper mounting hole on the 3RW5 communication module
between the 3RW5 communication module and the 3RW5 soft starter. Insert the slotted
screwdriver into this gap from above.
3. Turn the slotted screwdriver 90°. The turning movement lifts the 3RW5 communication
module slightly out of the slot of the 3RW5 soft starter.
4. Pull the 3RW5 communication module out of the slot of the 3RW5 soft starter with your
󹪝ngers.
Result
You have removed the 3RW5 communication module and can now mount another
3RW5 communication module.
4.3 Installing the 3RW5 communication module on a level surface
Requirements
• 3RW50 soft starter
• Level surface, e.g. su󹪟ciently strong mounting plate
• Observe the mounting positions, minimum clearances and ambient conditions stated on the
data sheet.
Mounting and dismantling
4.3 Installing the 3RW5 communication module on a level surface
SIRIUS 3RW5 PROFINET communication modules
Equipment Manual, 05/2021, A5E35631297002A/RS-AD/004 41