Siemens PROFINET SIRIUS 3RW5 - Configuring 3 RW5 soft starters without assistance from a 3 RW5 HMI High Feature

6.2.1 Con󹪝guring the 3RW5 Soft Starter in the PROFINET IO system
6.2.1.1 Con󹪝guring 3RW5 soft starters without assistance from a 3RW5 HMI High Feature
This section describes a possible con󹪝guration of the 3RW5 soft starter which you can only carry
out via the con󹪝guration software of the controller. You do not need a 3RW5 HMI High Feature
for this con󹪝guring option.
Requirements
• Connection of the 3RW5 soft starter via PROFINET
• Supply voltage (control supply voltage) switched on at 3RW5 soft starter
• MAC address
You can read the MAC address on the front of the 3RW5 communication module.
Procedure









① Programmable logic controller/IO controller, e.g. SIMATIC S7‑1500
② PC or programming device with con󹪝guration software of controller
③ PROFINET
④ SIRIUS 3RW5 soft starter / IO device

...

: Steps to be taken in the procedure
Con󹪝guring
6.2 Con󹪝guring the 3RW5 Soft Starter
SIRIUS 3RW5 PROFINET communication modules
Equipment Manual, 05/2021, A5E35631297002A/RS-AD/004 55