Installing terminal module TM‑PS‑A
1. Fit the terminal module onto the rail.
2. Push in the terminal module at the bottom until you can hear the catch lock.
3. Screw the terminal module to the mounting rail (2 screws - torque 0.8 to 1.1 Nm). Use a
screwdriver with a 4.5 mm wide blade.
Note
To prevent the ET 200iSP from slipping sideways on the mounting rail, you must secure the
terminal module mechanically (see point 3). The 2 fastening screws are located on the front
at the bottom of the terminal module.
An inserted Power Supply PS can only be uninstalled if both fastening screws are tightened
on the terminal module.
â‘ Catch
Figure 5-6 Installing terminal module TM‑PS‑A
Installing terminal module TM‑PS‑B (second power supply PS)
1. Hang the server module in the mounting rail TM‑PS‑B to the right of the TM‑PS‑A.
2. Swivel the TM‑PS‑B backwards until the slide audibly engages.
Installing
5.3 Installing the terminal module for power supply PS
ET 200iSP
110 Operating Instructions, 11/2022, A5E00247483-AK
To Next Page
Loading...
Need help?
General
