Use in industrial environment
Table 9-1 Use in industrial environment
Area of application Requirement for
Interference emission Interference immunity
Industry EN 61000-6-4:2007 + A1:2011 EN 61000-6-2:2005
Use in residential areas
Note
The distributed I/O system ET 200iSP is intended for use in industrial environments; when used
in residential areas, it can aect radio/television reception.
If you use the ET 200iSP in residential areas, then you must ensure the values of the EN
61000-6-3 measured according to EN 55016-2-3 for emission of radio frequency interference.
Individual measures are, for example:
• Installation of the ET 200iSP in grounded control cabinets/switch boxes
• Use of lters in supply lines
Approvals
ATEX- direc‐
tive
KEMA 04ATEX2242 (ET 200iSP system)
The module markings are described in the specications.
See technical specications of the ET 200iSP modules.
IECEx appro‐
val
See technical specications of the ET 200iSP modules.
INMETRO
See technical specications of the ET 200iSP modules.
FM approval Factory Mutual Research (FM)
See technical specications of the ET 200iSP modules.
cULus ap‐
proval
Underwriters Laboratories Inc.
See technical specications of the ET 200iSP modules.
CCC Ex ap‐
proval
See technical specications of the ET 200iSP modules.
General technical specications
9.2 Standards and certications
ET 200iSP
240 Operating Instructions, 11/2022, A5E00247483-AK
To Next Page
Loading...
Need help?
General
