Siemens SIMATIC ET 200iSP

UKCA DEKRA 21UKEX0032 (ET 200iSP system)
Importer UK:
Siemens plc
Manchester M20 2UR
See technical speci󹪝cations of the ET 200iSP modules.
Marking for
Australia
The ET 200iSP distributed I/O device meets the require‐
ments of standard EN 61000-6-4:2007 + A1:2011.
WARNING
Do not remove plug-in connectors during operation
Personal injury and property damage can occur.
In hazardous areas, personal injury and property damage may occur if plug connections are
disconnected during operation of a ET 200iSP plug-in connection.
Be aware of which activities are permitted in potentially explosive areas. See section "Activities
during operation (Page 225)".
IEC 61131
The ET 200iSP distributed I/O device meets the requirements and criteria of the standard
IEC 61131-2 (Programmable Logic Controllers, Part 2: Equipment Requirements and Tests).
PROFINET standards
The CC-B ET 200iSP distributed I/O device is based on the standards IEC 61158 and IEC 61784.
PROFIBUS standard
The ET 200iSP distributed I/O device is based on the standard IEC 61784-1:2002 Ed1 CP 3/1.
Marine approval
Classi󹪝cation authorities:
• ABS (American Bureau of Shipping)
• BV (Bureau Veritas)
• DNV (Det Norske Veritas)
• GL (Germanischer Lloyd)
• LRS (Lloyds Register of Shipping)
• Class NK (Nippon Kaiji Kyokai)
General technical speci󹪝cations
9.2 Standards and certi󹪝cations
ET 200iSP
Operating Instructions, 11/2022, A5E00247483-AK 241