Siemens SINUMERIK 840D sl Commissioning Manual

InternalLldpTLVsTxEnabled
Using this parameter, additional information in the LLDP packets are enabled at X120/X127,
which are normally not included.
Value: Numerical value from 0 ... 15
Default: 0
The value is a bit field, i.e. the total value is obtained as a sum (total) of the specified numbers,
if the corresponding information is to be sent:
1: port description
2: system name
4: system description
8: capabilities
ExternalLldpTLVsTxEnabled
Using this parameter, additional information in the LLDP packets is enabled on the X130, which
are normally not included.
Value: Numerical value from 0 ... 15
Default: 0
The value corresponds to parameter InternalLldpTLVsTxEnabled.
2.3.7 Section [LinuxBase]
Description
Additional setting possibilities of the Linux system are combined in this section.
Note
Setting the time zone and the time server
The IP addresses can also be set directly from the SINUMERIK Operate user interface in the
"Commissioning" → "Date time >" softkey operating area.
Configuring the system
2.3 Configuration file "basesys.ini"
NCU operating system
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 25

Siemens SINUMERIK 840D sl Specifications

General

Control Type	CNC
Number of Axes	Up to 31
Max Number of Channels	10
Interfaces	Ethernet, PROFIBUS, PROFINET, USB
Interpolation	5-axis interpolation
Operating Temperature	0°C to 45°C
Relative Humidity	Up to 95% (non-condensing)
Display	TFT color display, various sizes
Programming Languages	DIN/ISO
Safety Features	Safety Integrated
PLC	Integrated PLC S7-300
Drive Interface	SINAMICS S120
Data Storage	CF card, USB
Operating System	Windows-based