Siemens SINUMERIK 840D sl Commissioning Manual

6.6 Restore a disk image of the SSD
If your system is no longer functioning stably, you can restore it with a disk image.
Note
Restoring replaces all current files
When you restore the PC system from a disk image, all programs, settings and files are
completely replaced by the disk image. You cannot restore individual files or exclude individual
files from restoration.
Requirement
A disk image exists
See: Create a disk image of the SSD (Page 128)
Procedure
To restore a disk image, proceed as follows:
1. Start the Service Center, e.g. via the Windows boot menu.
See also: Starting the Service Center (Page 122)
2. In the main menu of the Service Center, click "Disk Restore".
The "Disk Restore" dialog box opens.
Figure 6-5 Service Center - Disk Restore
Backing up and restoring data
6.6 Restore a disk image of the SSD
PCU Base Software (IM10)
130 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1

Siemens SINUMERIK 840D sl Specifications

General

Control Type	CNC
Number of Axes	Up to 31
Max Number of Channels	10
Interfaces	Ethernet, PROFIBUS, PROFINET, USB
Interpolation	5-axis interpolation
Operating Temperature	0°C to 45°C
Relative Humidity	Up to 95% (non-condensing)
Display	TFT color display, various sizes
Programming Languages	DIN/ISO
Safety Features	Safety Integrated
PLC	Integrated PLC S7-300
Drive Interface	SINAMICS S120
Data Storage	CF card, USB
Operating System	Windows-based