Siemens SINUMERIK 840D sl Commissioning Manual

6.13 Starting up the replacement SSD
Information on the replacement or installation of an SSD can be found in the hardware
documentation for your PC system:
● SINUMERIK PCU 50.5
– Manual SINUMERIK 840D sl Operator Components and Networking
● SIMATIC IPC
– SIMATIC IPC627 operating instructions
– SIMATIC IPC427 operating instructions
Note
Troubleshooting if reading in of the disk image fails
If data transfer is interrupted during the reading process, there will be no executable operating
system available on the Siemens PC system.
In this case, use a bootable USB flash drive with Service Center to read the disk image in
again.
See also
Network settings (Page 10)
Restore a disk image of the SSD (Page 130)
Backing up and restoring data
6.13 Starting up the replacement SSD
PCU Base Software (IM10)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 153

Siemens SINUMERIK 840D sl Specifications

General

Control Type	CNC
Number of Axes	Up to 31
Max Number of Channels	10
Interfaces	Ethernet, PROFIBUS, PROFINET, USB
Interpolation	5-axis interpolation
Operating Temperature	0°C to 45°C
Relative Humidity	Up to 95% (non-condensing)
Display	TFT color display, various sizes
Programming Languages	DIN/ISO
Safety Features	Safety Integrated
PLC	Integrated PLC S7-300
Drive Interface	SINAMICS S120
Data Storage	CF card, USB
Operating System	Windows-based