Siemens SINUMERIK 840D sl Commissioning Manual

6.2 Starting the Service Center
To start the Service Center, proceed in one of the following ways:
● To call up the Service Center on the SSD while the PC system is starting, select the "Booting
Service System" during startup in the Windows boot menu.
● To call up the emergency boot system on a USB flash drive while the PC system is starting,
set the service switch to E or press F12 during startup to show the boot selection.
● To switch to the Service Center while the Service Desktop (Windows 7) is active, click the
"ServiceCenter Backup-Restore" icon on the Desktop and then click "Start ServiceSystem".
Backing up and restoring data
6.2 Starting the Service Center
PCU Base Software (IM10)
122 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1

Siemens SINUMERIK 840D sl Specifications

General

Control Type	CNC
Number of Axes	Up to 31
Max Number of Channels	10
Interfaces	Ethernet, PROFIBUS, PROFINET, USB
Interpolation	5-axis interpolation
Operating Temperature	0°C to 45°C
Relative Humidity	Up to 95% (non-condensing)
Display	TFT color display, various sizes
Programming Languages	DIN/ISO
Safety Features	Safety Integrated
PLC	Integrated PLC S7-300
Drive Interface	SINAMICS S120
Data Storage	CF card, USB
Operating System	Windows-based