Siemens SINUMERIK 840D sl Commissioning Manual

If the HMI software of your OEM installation is not shut down within 180 seconds, you can
parameterize this wait time manually.
Note
Information about the test environment for machine OEMs
The "SITOP UPS" function has been tested in the standard configuration with the PCU base
software. When installing add-on or OEM software components, you must check the shutdown
procedure of the entire system and adapt the factory setting.
Requirement
● The SITOP UPS module is configured for use with the PCU base software.
See Configuring SITOP software V3.x (USB) (Page 54).
● The Service Desktop is active.
Configuration of the system
4.15 Configuring the SITOP UPS module for use with the PCU Base Software
PCU Base Software (IM10)
58 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1

Siemens SINUMERIK 840D sl Specifications

General

Control Type	CNC
Number of Axes	Up to 31
Max Number of Channels	10
Interfaces	Ethernet, PROFIBUS, PROFINET, USB
Interpolation	5-axis interpolation
Operating Temperature	0°C to 45°C
Relative Humidity	Up to 95% (non-condensing)
Display	TFT color display, various sizes
Programming Languages	DIN/ISO
Safety Features	Safety Integrated
PLC	Integrated PLC S7-300
Drive Interface	SINAMICS S120
Data Storage	CF card, USB
Operating System	Windows-based