Siemens SINUMERIK 840D sl Commissioning Manual

Precondition
● The PG/PC is linked with the Siemens PC system in one of the following ways:
– The PG/PC is connected to the PC system with an Ethernet cable (either directly or via
a switch)
See: Connection options in the system network (Page 141)
– The PG/PC is networked with the PC system via an interface on the NCU and the routing
is configured.
See: Configuring routing in the network (Page 144)
● A current Microsoft Windows operating system is installed on the PG/PC
● The PG/PC is switched on
Backing up and restoring data
6.12 Operating a service PC/PC in the network
PCU Base Software (IM10)
146 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1

Siemens SINUMERIK 840D sl Specifications

General

Control Type	CNC
Number of Axes	Up to 31
Max Number of Channels	10
Interfaces	Ethernet, PROFIBUS, PROFINET, USB
Interpolation	5-axis interpolation
Operating Temperature	0°C to 45°C
Relative Humidity	Up to 95% (non-condensing)
Display	TFT color display, various sizes
Programming Languages	DIN/ISO
Safety Features	Safety Integrated
PLC	Integrated PLC S7-300
Drive Interface	SINAMICS S120
Data Storage	CF card, USB
Operating System	Windows-based