Siemens SINUMERIK 840D sl Commissioning Manual

Example
<!-- Work offset: -->
Note
In the comment itself, you can never use two minus signs one right after the other!
Special characters
If you use characters in the text where the syntax of XML is of significance, then these must
specifically formatted:
Special characters Notation
& &amp;
' &apos;
< &lt;
> &gt;
" &quot;
Comments in an ini file
If you enter a comment in an ini file, start the comment line with a semicolon.
Copy file
Using the "WinSCP" or "Access MyMachine" program, copy the file from an external computer
to the NCU via a network connection – or in the opposite direction from the NCU to an external
PC.
For a detailed description, see the following sub-book:
References
NCU Operating System (IM7): Backing up and restoring data and WinSCP and PuTTY service
tools
See also
Configuring alarm and message texts via alarm text files (Page 257)
Principles of start-up
2.2 Editing files
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 27

Siemens SINUMERIK 840D sl Specifications

General

Control Type	CNC
Number of Axes	Up to 31
Max Number of Channels	10
Interfaces	Ethernet, PROFIBUS, PROFINET, USB
Interpolation	5-axis interpolation
Operating Temperature	0°C to 45°C
Relative Humidity	Up to 95% (non-condensing)
Display	TFT color display, various sizes
Programming Languages	DIN/ISO
Safety Features	Safety Integrated
PLC	Integrated PLC S7-300
Drive Interface	SINAMICS S120
Data Storage	CF card, USB
Operating System	Windows-based