Siemens SINUMERIK 840Di sl - Page 32

General Information on the SINUMERIK 840Di sl
1.2 Overview of software components
Manual
32 Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
● SinuCom NC (installed)
Startup-Tool for the SINUMERIK 840Di sl NC
● SIMODRIVE 611 universal tool box
Contents:
– Toolbox for PLC-parameterization
Various files for assigning parameters to an S7 configuration with SIMODRIVE drives
(611U, POSMO SI, CD, CA) and PROFIdrive communication (see readme.txt)
(Example-files: <Installation path>\611utb\toolbox\<version>\<file>)
– SimoCom U
Startup-Tool for SIMODRIVE 611 universal/E and SIMODRIVE POSMO SI, CD/CA
drives
(installs and in addition to installation: <CD-path>\611utb\SimoComU\Setup.exe)
– SIMODRIVE 611 universal Drive-Firmware
(Firmware file: <Installation path>\611utb\Sys611U\<version>\611u.ufw)
– SIMODRIVE 611 universal option module: "Motion Control with PROFIBUS DP"
firmware
(Firmware file: <Installation path>\611utb\dpc31\<version>\v1sl.ufw)
– SIMODRIVE POSMO SI, CD/CA Drive firmware
(Firmware file: <Installation path>\611utb\SysPosmo\<version>\posmo.ufw)
Note
SINAMICS drives
The drive commissioning tool: STARTER is not included in the SINUMERIK 840Di sl
scope of supply. The STARTER must be purchased separately. It is recommended
that you always use latest version.
References:
Catalog: NC 61 > SINAMICS S120 Drive System