Siemens SINUMERIK 840Di sl - Page 358

NC Commissioning with HMI Advanced
11.2 Machine and setting data
Manual
358 Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
Overview of setting data
The setting data are divided into the following areas:
Table 11-2 Overview of setting data
Area Description
from 41000 to 41999 General setting data ($SN_....)
from 42000 to 42999 Channel-specific setting data ($SC_....)
from 43000 to 43999 Axis-specific setting data ($SA_....)
Data description
For a detailed description of the machine or setting data, please refer to Function Manual of
the function that uses the machine data in question, e.g.:
References:
/FB/ Function Manual - Basic Functions
/FB/ Function Manual - Extended Functions
/FB/ Function Manual - Special Functions
A concise table of all machine and setting data is to be found in:
References:
/LIS/ Lists, Machine- and Setting Data
Note
To search for information regarding machine and setting data, it is recommended to use the
search functions in the electronic documentation of SINUMERIK DOConCD.