NC Commissioning with HMI Advanced
11.5 Axes and spindles
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
459
DB number Bit, byte Name
31, ... 83.2 Setpoint speed increased
31, ... 83.1 Setpoint speed limited
31, ... 83.0 Speed limit exceeded
31, ... 84.7 Active spindle control mode
31, ... 84.6 Active spindle mode oscillation mode
31, ... 84.5 Active spindle positioning mode
31, ... 84.3 Tapping with compensation chuck active
31, ... 86 and 87 M function for spindle
31, ... 88-91 S function for spindle
To Next Page
Loading...
