Siemens SIREMOBIL Iso-C

Adjustments / Programs 5 - 29
Siemens AG SPR2-230.061.01 Page 29 of 30 SIREMOBIL Iso-C
Medical Solutions Rev. 13 12.04 CS PS 24 System Manual
Configuring the MEMOSKOP 5
MEMOSKOP C-E, keyboard emulation 5
There is no keyboard supplied with some SIREMOBIL Iso-C units and installed
MEMOSKOP C-E.
When replacing the MEMOSKOP C-E or when changing the configuration, the
MEMOSKOP service program should be used.
The help file "C-DATA.hlp" will be copied to the service PC during installation of the
MEMOSKOP service program. The "C-DATA.hlp" help file contains descriptions of the
programming.
Configuring the video frequency 5
After replacing the MEMOSKOP, it will start at a default video frequency (50 Hz). If the
monitors were configured for a different frequency, you will have to configure the
MEMOSKOP.
Without installed MEMOSKOP keyboard:
• Use the MEMOSKOP service program to modify the configuration.
With installed MEMOSKOP keyboard:
• Invoke Technical Setup on MEMOSKOP (press the CTRL + T keys).
• Press the "2" key and press return. The video frequency menu is selected.
• Depending on the required video frequency, press the right cursor key "->".
"->" = Press the right cursor key
"<-" = Press the left cursor key
Roadmap K-factor, phase B Noise suppression, phase B, is programmed in the road-
map mode.
Phase B: Acquisition of fill images.
Roadmap K-factor, phase C Noise suppression, phase C, is programmed in the road-
map mode.
Phase C: Acquisition of roadmap images.
Roadmap Time of phase A The time of phase A in the roadmap mode is programmed.
Phase A: Mask acquisition.
(1) in menu Diagnostics
"->" pressed 1 time:
"->" pressed 2 times:
"->" pressed 3 times:
"->" pressed 4 times:
60 Hz video frequency
100 Hz video frequency
120 Hz video frequency
50 Hz video frequency
Key "->": (Start "->" "->" "->" "->" ...
Video frequency 50 Hz 60 Hz 100 Hz 120 Hz 50 Hz etc...
Key "<-": "<-" "<-" "<-" "<-" "<-" "<-"
Function: Comments: