Display 9810 series - User manual
175 7EN05-0390-08
The Display Options screen is displayed.
4. Select the Setup Registers tab.
5. Select the display units you want to configure: Voltage Units, Current Units, Power Units or
Energy Units. Click Edit.
A unit selection screen is displayed.
6. Select the desired units from the drop-down list, and then click OK.
7. When you have finished configuring the display units, click Send to send your changes to
the meter and close the Display Options screen.
For more information on the Display Options module and your meter’s ION architecture, see ION
Reference, available on www.usa.siemens.com/pds.
Remote display troubleshooting icons
The remote display shows troubleshooting icons in addition to the meter’s status LED information.
Icon Description
The display is connecting to your meter.
The display cannot communicate to your meter. Check the connection
between your meter and the display. Check the meter’s status LED to
confirm that the meter is operating normally.
The display needs updated firmware for compatibility with your meter.
The display is downloading a firmware upgrade. Do not disconnect the
display from your meter.
The display is undergoing a firmware upgrade. Do not disconnect the
display from your meter.
To Next Page
Loading...
