Siemens US2:9810RC - Loading Option Module Firmware Using SFTP

Firmware upgrades 9810 series - User manual
271 7EN05-0390-08
Loading option module firmware using SFTP
Upload firmware to your meter’s option modules by loading the firmware upgrade file onto your
meter’s internal SFTP site. Each option module must be upgraded individually.
Prerequisites:
•
Option module firmware upgrade (.S19) file(s). Go to www.usa.siemens.com/pds to
download upgrade files.
•
Option module is connected to the meter.
•
Access to meter’s internal SFTP site.
The meter’s digital and analog outputs may change state during a firmware upgrade. Option
modules are offline during an option module firmware upgrade. They will not communicate to the
meter and the outputs may change state during the upgrade process.
WARNING
UNINTENDED OPERATION
Failure to follow these instructions can result in death, serious injury, or equipment
damage.
Do not use this device for critical control or protection of persons, animals, property, or
equipment.
NOTE: If your meter’s option module loses power during firmware upload, the option module will
revert to its original firmware and you will have to reload the firmware file.
To load firmware option module firmware using SFTP:
1. Connect to your meter’s internal SFTP site.
2. Open the (optionModuleUpg) folder.
3. Open the option module folder that applies to the module to be upgraded.
4. Drag the option module firmware file into the option module upgrade folder.
The file is immediately transferred to the option module, and is not stored on the meter.
5. Review the option module firmware upgrade details stored in the meter’s event log to
confirm that the upload was successful. The upgrade folder must match the position of the
option module (A through D).