Data recorder Description
V2 Hrm 17-32 (Data Rec 48) V2 voltage harmonics - 10 min
V2 Hrm 33-48 (Data Rec 54) V2 voltage harmonics - 10 min
V3 Hrm 1-16 (Data Rec 43) V3 voltage harmonics - 10 min
V3 Hrm 17-32 (Data Rec 49) V3 voltage harmonics - 10 min
V3 Hrm 33-48 (Data Rec 55) V3 voltage harmonics - 10 min
Configuring data logging using ION Setup
Use ION Setup to configure the meter’s data recorders.
Changing the meter’s data recorder configuration clears existing data in that data recorder.
NOTICE
DATA LOSS
Failure to follow these instructions can result in data loss.
Ensure that all important data is recorded before configuring data recording.
To configure data logging using ION Setup:
1. Start ION Setup.
2. Open the Setup Assistant for your meter.
3. Click Logging > Memory.
4. In the Status tab, select the data log and click Edit.
The Log Depth Setup window appears.
5. Configure the settings as applicable:
Parameter Description
Log Interval How frequently records are logged
Log Depth Maximum number of records stored in the log
Log Memory
Information only. This is automatically calculated, and displays
how much memory the log uses based on the Log Interval
and Log Depth
Log Storage
Information only. This is automatically calculated, and displays
how much total memory is left after subtracting the Log
Memory usage
Waveform recording
The meter’s factory-configured waveform recorders store waveform data related to power quality
events.
9810 series - User manual Logging
7EN05-0390-08 226
To Next Page
Loading...
